Carrier furnace, Bryant AC & coil installation in San Jose, CA

Nur HVAC installed a complete heating and cooling system for this home: a new Carrier 2-stage furnace (model 58TP1A090V17), a new Bryant 2-stage air conditioner (model 127TAN04800W), and a new Carrier 48,000 BTU coil. The work covered the full furnace, AC, and coil replacement from start to finish.

A full HVAC installation involves choosing the right equipment for the building’s size, usage, and climate, then installing and connecting each component. Pairing a furnace, air conditioner, and coil that are matched to one another helps the whole system run efficiently and comfortably. Here is how that process typically unfolds.

The HVAC installation process

• Conduct a site survey: the technician assesses the building’s existing infrastructure, including the electrical and plumbing systems, to determine the best location for the equipment.
• Size the equipment: the technician selects the appropriate furnace, air conditioner, and duct sizing based on square footage, insulation levels, and climate.
• Install the equipment: the furnace, air conditioner, and ducts are installed, properly connected, and sealed.
• Match the components: the furnace, AC, and coil are selected to work together as a single, balanced system.
• Test and commission: the technician tests the complete system to confirm it is working properly and makes any needed adjustments.

It is important to choose a qualified and experienced HVAC contractor so the system is installed correctly and runs efficiently. Nur HVAC followed this process for this Carrier and Bryant installation, sizing each component to the home and verifying the system before the job was complete.